Installation instruction book
First of all thank you to purchase and use our products, I hope our products can bring you the convenience and comfort.
Before using this unit, please read this manual. So that you can safe, correct operation and maintenance, and makes the machine has long maintained good working state.
Specification |
Unit |
Value |
Voltage |
V |
220/380 |
Breeze pressure |
Pa |
≤-150 |
Noise |
dB |
≤72 |
Power |
W |
750 |
Pump power |
W |
250 |
Heating power |
KW |
3 |
Rated evaporation |
KG |
4.3 |
Rated steam pressure |
MPa |
0.4 |
Steam temprerature |
℃ |
151 |
Effictive water volume |
L |
15 |
Dimension |
mm |
1700×500×1930 |
Weight |
KG |
180 |
10. The insulation resistance between the charged and uncharged bodies in the
cold state should be greater than 2 megohms. After using it for a period of time, it should be detected in time;
11. If you are not ready to use the machine for a long time, please fill the pot with water and close all valves to prevent corrosion of the furnace;
12. To ensure the ironing effect, the tablecloth and sponge on the rock arm should be cleaned or replaced frequently.
Malfunction |
Cause of issue |
Solution |
The motor doesn’t work after turn on |
connection
|
1.Check the circuit 2.Replace 3.Replace |
The motor is Working without wind function |
1.Air duct blocked 2.Tablecloth and sponge blocked |
1.Clear the blockage 2.Clean or replace |
The motor is work but only wind sucks or blows |
1.Blow(suction)wind switch damaged 2.The lubricat on the wind tunnel is dry 3.Pneumatic component solenoid valve or cylinder damaged |
1.Replace 2.Remove dried lubricant and reapply 3.Replace |
Small air volume |
|
and check the air supply pressure |
Fan no working |
|
|
The electric heating tube does not work after the generator is started |
contact
is damaged 3.AC contactor burned out 4.Water is not added to the set level |
1.Check circuit 2.Replace 3.Repalce 4.Keep fill water to the set level |
The pressure doesn’t rise for a long time |
damaged |
|
The electric heating tube can’t stop working when the pressure gauge indicates that it has exceeded 0.4MPa |
1.The pressure controller is failure |
1.Replace |
AC contactor keeps jumping back and forth |
1.The voltage below 200V 2.The pressure controller is failure |
1.Install the regulator 2.Replace |